Quick Overview
- Bently Nevada 330702-00-26-50-01-05 proximity probe
- Member of the 3300 XL 11 mm monitoring family
- Designed for shaft vibration and position detection
- Manufactured in the United States
- Built for continuous industrial duty
Why This Probe Stands Out
- 11 mm probe diameter improves signal strength
- Armored cable resists wear and impact
- PPS tip handles oil and high heat
- Stable output over long distances
- Approved for hazardous locations
Model Number Logic
- 330702-00-26-50-01-05
- 330702
- 3300 XL series probe
- 11 mm sensing diameter
- 1/2-20 UNF mounting thread
- Stainless steel armored design
- 00
- Zero unthreaded length
- 26
- 2.6 inch probe case length
- 50
- 5.0 meter total probe length
- For 5 meter Proximitor sensor only
- 01
- Miniature coaxial ClickLoc connector
- Connector protector included
- Standard probe cable
- 05
- Multiple international approvals
- 330702
Electrical and Signal Data
- Probe DC resistance equals 7.2 ohms
- Resistance tolerance equals ±0.8 ohms
- Triaxial cable impedance equals 75 ohms
- Low signal loss over 5 meter length
Mechanical Specifications
- Probe case material AISI 304 stainless steel
- Probe tip material PPS
- Maximum thread engagement 0.750 inch
- Recommended mounting torque 15.2 N·m
- Maximum rated torque 45.2 N·m
Cable and Connector Limits
- FEP insulated probe cable
- Connector torque finger tight only
- Maximum connector torque 0.565 N·m
- Minimum bend radius 25.4 mm
Environmental Capability
- Operating temperature from -52°C to +177°C
- Stable sealing with Viton O-ring
- Designed to handle pressure differences
- Humidity resistant construction
Certifications and Area Rating
- Suitable for EPL Ga and Gc zones
- Approved for Zone 0 and Zone 2 use
- Supports intrinsic safety systems
Typical Industrial Uses
- Steam and gas turbines
- Large compressors
- Critical rotating shafts
- Continuous vibration monitoring
Warranty and Delivery
- Standard warranty 12 months
- Worldwide shipping available
- FedEx, UPS, or DHL supported
Professional FAQ
- Is this probe interchangeable with 8 mm types
- No. Diameter and calibration are different.
- Why must it match a 5 meter Proximitor
- System tuning depends on cable length.
- Can it handle strong vibration environments
- Yes. Armored cable improves durability.
- What affects pressure seal life
- Very low temperatures below -34°C.
- How do I confirm correct probe selection
- Check clearance, thread type, and monitor model.
Related Series
Contact Information Inquiries:
info@oiltechcontrols.com
|
+86 158 8020 0923
Copyright © 2025 Oiltech Controls Limited. All rights reserved.
Original Source:
https://www.oiltechcontrols.com/
Partner
PLCDCS HUB Limited.
All rights reserved.
Reviews
There are no reviews yet.