FMBA-01 ABB Modbus RTU Adapter Module for Drive Option Slot
FMBA-01 is a Modbus RTU adapter that plugs into the option slot of an ABB drive. It links the drive to an RS-485 bus through a 20-pin drive connector and a 4-pin detachable screw terminal. Because the bus interface is functionally isolated from the drive, ground loops and noise coupling stay out of the control electronics. A built-in 120 ohm terminator and a 6-pin jumper block simplify trunk line setup. Three green LEDs show power, receive, and transmit activity during commissioning. Every unit ships with a 12-month warranty.
Module Layout and Connectors
- X2: 20-pin connector to the drive option slot
- X1: 4-pin detachable screw terminal to the bus
- J1: 6-pin jumper block for bus termination
- Mounting: direct fit into the drive option slot
- Power: +3.3 V ±5%, max 150 mA, supplied by the drive
RS-485 Link Data
- Physical layer: asynchronous, half-duplex RS-485
- Topology: trunk line with drop lines allowed
- Cable: shielded twisted pair, 100 to 150 ohm impedance
- Termination: 120 ohm, built into the module
- Transfer rate: up to 5 Mb/s
- Protocol: application dependent, typically Modbus
- Compatibility: all RS-485 compliant devices
Diagnostic LEDs
- HOST (green, steady): module is powered up
- RXD (blinking): data arrives from the bus, addressed or not
- TXD (blinking): module sends data to the bus
Environmental and Compliance Notes
- Degree of protection: IP20
- Ambient conditions: per drive manual limits
- EMC: EN 50081-2 and EN 50082-2 compliant
- Materials: all UL/CSA approved
- Estimated minimum lifetime: 100 000 h
- Isolation: bus interface isolated from drive
Which Systems Suit This Adapter
- ABB drives with a free option slot and RS-485 needs
- Modbus RTU networks on trunk line topology
- Panels with shielded twisted pair wiring already in place
- Retrofit lines that need isolated bus communication
- Multi-drop setups with several drives on one segment
FAQ
Q: Do I need an external 120 ohm resistor at the bus end?
A: No. The FMBA-01 has a built-in 120 ohm terminator. Set J1 correctly and terminate only the physical bus ends.
Q: Why does RXD blink when the drive is not addressed?
A: RXD shows all bus traffic, not just frames for this node. Use protocol-level checks to confirm addressing.
Q: Can I run 5 Mb/s over long drop lines?
A: Not safely. High rates need short drops and clean trunk wiring. Lower the rate if errors appear.
Q: How do I confirm the module is powered?
A: The HOST LED stays steady green when the drive supplies +3.3 V. A dark HOST LED points to slot contact or drive supply.
Q: What should I check before ordering a replacement?
A: Send the drive model, option slot photo, and current jumper setting. We verify fit and termination setup before shipment.










Reviews
There are no reviews yet.