Allen-Bradley 280D-F23Z-25D-RRW-3 ArmorStart | Motor Controller

Allen-Bradley 280D-F23Z-25D-RRW-3 ArmorStart® Distributed Motor Controller

The 280D-F23Z-25D-RRW-3 is a strong on-machine motor starter made for harsh sites.
It offers fast plug-in wiring, safe full-voltage start, and clear LED fault signals.

Main Structure Overview

• Starter Type
  • Full-voltage start
  • Reversing function
  • HOA keypad option
• Power & Motor
  • 0.5…10 Hp (0.37…7.5 kW)
  • Contactor size: 23Z (24 VDC)
  • Motor cable: 3 m cordset (standard)
  • Short-circuit protector: 25 A
• Enclosure
  • IP67 / NEMA 4 / 4X
  • Shock and washdown ready
• Connections
  • Round media male port (RRW)
  • Quick disconnect I/O
  • ArmorConnect or conduit entry
• Control & I/O
  • Inputs: 4 (10–26 VDC)
  • Outputs: 2 relays (240 VAC / 30 VDC)
  • Backplane load: 400 mA
• Protection
  • Phase loss & phase imbalance
  • Overload & short circuit
  • Control power loss
  • Over-temperature trip
  • DeviceNet power fault

Extra Technical Highlights

• Input current: 3.0 mA @ 10 VDC / 7.2 mA @ 24 VDC
• Output thermal limit: 2 A total
• Relay dielectric strength: up to 2000 VAC
• Operating temp: –20…+50 °C
• Storage temp: –25…+85 °C
• Sensor power: 11…25 VDC from DeviceNet
• LEDs show power, run, network, and trip
• Built-in reset button
• Peer-to-peer DeviceNet ZIP support
• Works with ArmorPoint I/O for expansion
• 12-month warranty
• Shipping options: FedEx / UPS / DHL

Product Advantages

• IP67 body lowers risk from dust and washdown
• Plug-and-play ports reduce wiring hours
• LEDs guide field repair with simple color cues
• Strong relay outputs allow mixed AC/DC loads
• Safe shutdown on phase or heat faults

FAQ

• What should I check first when the unit trips?
  • Look at the fault LED color to know if it is a phase, load, or heat issue.
• How can I shorten install time?
  • Use the round media ports so power and motor lines plug directly in.
• Can I expand I/O?
  • Yes. ArmorPoint modules plug in and share power over DeviceNet.
• Why is the motor not running even with a start signal?
  • Check run LED and confirm that input filter delay is not set too long.
• Can I use AC and DC loads together?
  • Yes, the relay outputs support both if total current stays under 2 A.

Contact Information

• Email: info@oiltechcontrols.com
• Phone/WhatsApp: +86 158 8020 0923

Copyright © 2025 Oiltech Controls Limited. All rights reserved.
Original Source: https://www.oiltechcontrols.com/
Partner: PLCDCS HUB Limited